Table 6-S usually easy problems and treatment methods of

A, easy to form the primary site of abnormal sound of the following table:

1, 14- 5-, the big belt wheel swing plate brace rod 3, 9- 4, 7- spring eccentric shaft, the 6- bracket 6, saddle shaped footing on the swing box

Two, view methods and Countermeasures

1, for large pulley

Stop looking to use the hand to roll a large belt pulley, assuming that the belt pulley has a gap, it shows that the big belt wheel is not installed. So in the practice of the cost is very simple abnormal sound.

Methods: to find a piece of discarded hacksaw skin or a little thin small tin, stuffed into the keys of the big pulley in (commonly known as pin), then tighten the screws around, and can eliminate gaps in view.

2, the swing rod

Stop check, two cubits from around the top plate, with one hand to hold the big belt wheel, the other hand to swing the swing rod, under normal circumstances, can only be difficult at the mercy of swing, swing is not around. Assuming that the swing bar is not fixed. This kind of situation is not easy to produce abnormal noise.

Method: tighten the screw on the swing rod.

3, for the spring

Stop view. Look at the spring can go sight. Such as spring slanting or eccentric.

Treatment methods: with a hammer hitting spring, so you can force the spring reset.

4, for the eccentric shaft

Same stop view. The hands hold the big belt wheel, swing back and forth, if feel active or mechanical gap, the eccentric shaft is not fixed.

Methods: two small screw 6-S gear box oil on the cover.

5, elbow plate

Boot view. Touch the two elbow plate with one hand thumb and neutron separation (be sure to watch the view, think whether there is space safety).

Methods: according to the practice situation of the gap on the screw rod of the screw spring conditioning. If you send a tight point, if it is too tight.

6, the saddle four supporting plates on the footing

Stop view. Look at the direction of the four supporting plate can be accurate, such as whether it is in the middle of the swing box, as well as to see whether it will be blown to the side wall of the swing box.

Processing method: adjust the support plate position, make it in the exact position

To pouring concrete and anchor bolts embedded a good equipment before 1. The equipment should pay attention to the essential two slope base circle radius of 360 mm and a three bed linkage center in the same plane, or on the bed surface tilt, will accelerate the wear of copper sleeve, and the reciprocating rod break. As for the height of the traction screw of the linkage seat and the bed surface, the bolt under the rocking box can be adjusted to eliminate the error.

2 this table has been empty load commissioning qualified at the factory, the user should first make two small space charge in equipment commissioning work well, and check the following: starting the working process of the motor can work properly; touch and conflict joint surface wear parts; whether there is abnormal noise; lubricating ability normal etc.. Then stop the load test. After 24 hours and then see the above.

3 test work time and work load spring pressure should not be too tight, should be slightly relaxed, so that the work of elbow plate and its support to announce slender impact sound, then gradually conditioning will spring bolt, pressing to the sound can be interrupted. Press the spring will add excessive wear and power consumption, and may the spring spring pressure crushed, too loose is a simple form of elbow plate fade trouble, damage the box body parts.

4 trial should first pay attention to the direction of the rotation of the head pulley can be inconsistent with the picture, the steering should not be corrected immediately, otherwise the pump can not work properly. All screws must be tightened before driving. Because of the gear pump is driven by the crankshaft bed work, all lubricating points after departure time without oil, so the head part of each lubricating point must pour to dilute oil, in order to avoid damage to parts of shipment.

Sincerity for your reply, I hope to help you, http://www.scxcxksjxsbc.com/